Monday, August 6, 2012

Milkhouse Pre-Post Teat Dip




Generic Name: iodine liquid

Dosage Form: FOR ANIMAL USE ONLY
Pre-Post 1/2%

TEAT DIPPING IN COLD WEATHER:

When the temperature falls below 10 degrees F, or when wind chill is significant,

special precautions should be taken to avoid chapped and frozen teats.


1. Teats should be dry before turning cows out into cold weather.

2. When teats are dipped after milking, allow 30 seconds contact, and blot

    off any excess teat dip with a single service towel.

3. Warm the teat dip to reduce drying time.

4. Provide windbreaks in outside areas for cows.

5. Monitor fresh cows with swollen udders and teats since they are more

    susceptible to chapped and frozen teats.


PRODUCT INFORMATION:  This teat dip is an IODOPHOR (a combination of

iodine and complexing agents), and when properly used, is effective as an

aid in reducing the spread of mastitis causing organisms.  IODOPHORS are

considered relatively non-toxic, but should always be used in accordance

with label directions.  Consult your veterinarian in case of teat irritation.


DO NOT DILUTE.  USE AT FULL STRENGTH.


Important Use Instructions


For Pre-Milking

1.  Wash each individual teat with a sanitizing udder wash.  NOTE: For best results,

     keep hair around teat based clipped.

2.  Hand strip teats to initial let down.

3.  Pre-dip entire teat with PRE-POST 1/2% on all four quarters.  Repeat process on

     next 4 to 6 cows or until first cow prepped has at least 1 minute contact time.

4.  Wipe each individual teat with a clean paper towel.  Utilize a "pulling down" motion

     which removes iodine solution, germs, and sediment from teat skin. Very

     important!

5.  Place machine on cow and repeat wiping process on remaining cows that have

     been predipped.


For Post Milking

DIRECTIONS FOR TEAT DIPPING.  Dip entire teat with undiluted dip solution.  Allow

to air dry and remain on teats for prolonged contact time.  Clean, sanitize and

thoroughly dry each teat prior to next milking.  Replace dip solution when visibly

cloudy or dirty.

PROTECT FROM FREEZING CAUTION

Not for internal use.  Avoid contamination of foods.  Avoid contact with

eyes.


FIRST-AID

EYES: Immediately flush eyes with plenty of cool running water for at

least 15 minutes.


INTERNAL:  If swallowed, drink large quantities of water. DO NOT induce

vomiting.


GET MEDICAL ATTENTION IMMEDIATELY

KEEP OUT OF REACH OF CHILDREN


FOR ASSISTANCE WITH MEDICAL

EMERGENCY CONTACT:

CHEM-TEL, 1-800-255-3924
MILKHOUSE BRAND

Pre-Post 1/2%

A SANITIZING PRE AND POST DIP

An Aid in Reducing the Spread of

Organisms Which May Cause Mastitis


Active Ingredient............................0.5% Available Iodine

Emollient System Contains............5% Glycerin

Minimum pH...................................4.0


CAUTION:

KEEP OUT OF REACH OF CHILDREN


NET CONTENTS:  1 U.S. FL. GALLON (3.78 LITERS)


STEARNS PACKAGING CORPORATION

4200 Sycamore Avenue - Madison, Wisconsin 53714








MILKHOUSE BRAND PRE-POST 
iodine  liquid










Product Information
Product TypeOTC ANIMAL DRUGNDC Product Code (Source)60282-1106
Route of AdministrationTOPICALDEA Schedule    








Active Ingredient/Active Moiety
Ingredient NameBasis of StrengthStrength
IODINE (IODINE)IODINE0.5 L  in 100 L






Inactive Ingredients
Ingredient NameStrength
GLYCERIN5 L  in 100 L


















Product Characteristics
Color    Score    
ShapeSize
FlavorImprint Code
Contains      






















Packaging
#NDCPackage DescriptionMultilevel Packaging
160282-1106-13.78 L In 1 BOTTLE, PLASTICNone
260282-1106-218.93 L In 1 PAILNone
360282-1106-356.78 L In 1 DRUMNone
460282-1106-4208.2 L In 1 DRUMNone










Marketing Information
Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
unapproved drug other06/21/2004


Labeler - Stearns Packaging Corporation (006069256)

Registrant - Stearns Packaging Corporation (006069256)









Establishment
NameAddressID/FEIOperations
Stearns Packaging Corporation006069256manufacture
Revised: 09/2010Stearns Packaging Corporation



No comments:

Post a Comment